Front Turn Signal Removal Help

lostkk24 · **Joined:** Mon Jul 25, 2011 1:31 am **Posts:** 7

I'm trying to remove my front turn signals, and I couldn't figure out how to remove them. Can anyone help me out??
Any pictures would help greatly.

Thanks

lfhoward · **Posted:** Mon Jan 02, 2012 9:22 pm

Page 444 of the 2008 owners manual has instructions on replacing the bulb:

Front Turn Signal and Front Side Marker Lights

1. Turn the steering wheel all the way to the right to access the left front turn signal or side marker. Turn the steering wheel all the way to the left to access the right front turn signal or side marker.

2. Remove three push-pins from the wheel-well liner.

3. Gently flex the wheel-well liner forward to access the bulb.

4. Rotate the bulb's socket counterclockwise, and remove the bulb and socket assembly from the housing.

5. Pull the bulb out of the socket and insert the replacement bulb.

6. Install the bulb and socket assembly into the housing, and rotate the socket clockwise to lock it in place.

7. Reposition the wheel-well liner and install the push-pins.

If you are trying to remove the front turn signal's plastic housing or lens, sorry, I don't know! The 2008 factory parts manual (Lamps Front Figure 8-1105) doesn't shed much light on this.

Diggerfreek · **Posted:** Tue Jan 03, 2012 12:04 am

If you want to remove the housing, it's basically the same. There is one retaining "nut" that is a 11MM IIRC...

If you need I might have pictures.

lostkk24 · **Joined:** Mon Jul 25, 2011 1:31 am **Posts:** 7

Diggerfreek wrote:

If you want to remove the housing, it's basically the same. There is one retaining "nut" that is a 11MM IIRC...

If you need I might have pictures.

Yeah if you do have any pictures that would be great!
Thanks so much

Diggerfreek · **Posted:** Wed Jan 04, 2012 3:08 am

I'm so good :twisted:

Ok, once you get the wheel well liner out of the way, get a flashlight and look for the forest green connector. The green connector is the light bulb socket.

This picture was taken with the bumper off, but you can get the housing out with out removing the bumper.

The 2 silver things at the 11 o'clock and 4 o'clock position are the retaining "nuts"

Once the nuts are off, just push on the housing from the wheel well. There is this little clip that you must over come.

Should this clip stay inside the bumper skin, just use a pair of needle nose pliers and pull it out and push it back on the housing..

lostkk24 · **Joined:** Mon Jul 25, 2011 1:31 am **Posts:** 7

Thanks dude your the man!

Front Turn Signal Removal Help

Who is online