I recently have been experiencing a lot of steering wheel vibration, especially at higher speeds. My first thought is a wheel bearing. Any ideas? I currently have 120,000 miles in my 06 KJ.

_________________
2006 CRD Limited

If it's while braking, consider runout on the rotor as a cause - and get it turned or replaced.

If it's while running, is it while accelerating, decelerating, maintaining, or ? Consider CV joints, bent wheel, perhaps a U-joint, wheel out of balance.

Mark

_________________
--
2005 Liberty CRD
2004.5 Cummins 5.9L TD, F1s, NV5600 6-speed in a '93 GMC Suburban

It's while cruising, I have replaced both front and back rotors. It is a constant vibration and increases with speed.

_________________
2006 CRD Limited

I've seen tires go bad internally - sometimes you can even see the bubble on the tread or sidewall.

Of course, there's always "out of balance" and sometimes out of round. Any good tire shop could help you find all of the above.

Typically, a place like Les Schwab could also check the CV joints.

Mark

_________________
--
2005 Liberty CRD
2004.5 Cummins 5.9L TD, F1s, NV5600 6-speed in a '93 GMC Suburban

Also check the ball joints and control arm bushings.

_________________
05CRD: GDE Hot ECU & TCM tunes, Provent, Cat filter, Facet lift pump, TransGo kit, Florida TC, Samcos, stainless brake lines, HDS thermostat, Renegade light bar,
Bilstein adjustables, Al's Gen 4.5 Arms, 235/85-16 Duratracs, DTT rear, Elocker front, EVIC+TPMS, Turbo timer, McNally pillar gauges, Weeks Stage II kit.