I didn't show the insides, it's on a single sided PCB using all SMT components. I was planning on supplying a built assembly only, probably sealed with just the six wires in a single cable for the user to splice in. It's an unobtrusive black box, 1" x 1.5", for the price of an un-assembled SEGR.

Yes, the picture shows a mess, but that was me in the middle of it. It's all buttoned up now.

_________________
'05 Liberty CRD B100, SEGR - SOLD

'01 Beetle TDi B100, EGR delete
'83 Mercedes 240D B100, no EGR

--- SEGR Builder ---

Let us know.
Thanks

_________________
2006 Pearl Green CRD
Magnaflow 2 1/2" Cat Back
KJ Extra Leg Room Brackets, Carter Lift Pump, V6 Airbox, ORM
Fuel cooler, Oil Separator, Progard 7
Gauges EGT Boost Trans Temp Oil Pres, Michelin LXT AT2 245 70 R16
7,000# Draw Tight hitch, PML EX Deep Trans Pan
Centrifuge, SunCoast, Transgo, RAM TCM, InMotion Stage 2
Wife's 99 TDI VW Beetle

Here is some pictures of my device. Now that I am done tweeking it, I plan on replacing the individual wires with a single lighter gauge cable and deleting the connector to eliminate points of failure. I am ordering parts to build up the rest of my PCBs, and I will have about 8 of my first run available. The box is 2"x1"x0.5".

_________________
'05 Liberty CRD B100, SEGR - SOLD

'01 Beetle TDi B100, EGR delete
'83 Mercedes 240D B100, no EGR

--- SEGR Builder ---