It is currently Wed Nov 04, 2026 10:02 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: egts after lift pump install
PostPosted: Wed Jul 18, 2012 2:48 am 
Offline
LOST Newbie
User avatar

Joined: Sun Sep 04, 2011 9:56 pm
Posts: 66
been driving the liberty with the cummins in tank lift pump for about a week now and am very happy with the results. ive only used a half tank of fuel and cant tell if the miliage is better or not, but i have noticed my egts are now 50F cooler than usual! has anybody else with a lift pump installed noticed this?

_________________
06 cummins 3500 many mods 600+hp


Top
 Profile  
 
 Post subject: Re: egts after lift pump install
PostPosted: Sun Jul 22, 2012 11:05 pm 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Sat Jun 09, 2007 10:49 pm
Posts: 3554
Location: Aurora, IL
You got rid of the small air leaks that cause fuel aeration.
Now your timing is where your tune dictates with out the
delay caused by the fuel aeration, that is why your
EGTs have dropped.
Open up the exhaust by getting rid of the stock muffler
and the 2 1/8" choke point on the rear CAT flange, your
EGT will drop some more.
Go with SEGR or ORM and your EGTs will drop some more.
Install a Hayden Severe Duty fan clutch and 11 blade
nylon fan, your EGTs will drop even more because more
air will flow over the intercooler.

_________________
2006 Pearl Green CRD
Magnaflow 2 1/2" Cat Back
KJ Extra Leg Room Brackets, Carter Lift Pump, V6 Airbox, ORM
Fuel cooler, Oil Separator, Progard 7
Gauges EGT Boost Trans Temp Oil Pres, Michelin LXT AT2 245 70 R16
7,000# Draw Tight hitch, PML EX Deep Trans Pan
Centrifuge, SunCoast, Transgo, RAM TCM, InMotion Stage 2
Wife's 99 TDI VW Beetle


Top
 Profile  
 
 Post subject: Re: egts after lift pump install
PostPosted: Sun Jul 22, 2012 11:38 pm 
Offline
LOST Newbie
User avatar

Joined: Sun Sep 04, 2011 9:56 pm
Posts: 66
thanks for the reply that makes sense why it dropped.. well i just swapped out cat and muffler for a straight pipe today so thats covered! i have no need to do the orm as believe the gde tune takes care of that. i have been thinking about a better fan.. wat kind of egts temps do u see with everything done?? if u have a gauge?

_________________
06 cummins 3500 many mods 600+hp


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com