Hey guys, I've been looking all over for a source to replace the TPM's in my wheels (getting new steel's mounted) and need the rubber ones vs. the metal ones. Can anyone provide a part # (OE or generic) or a link to purchase them?

Thank you!

You got to use the correct part# TPMS,if not they will not be detected by the system.In most cases if you have metal stemmed sensors you must use that part # only for replacements.

The sensor is attached to the stem with a small screw. You should be able to replace the stems and still use the sensors.

_________________
2010 KK Deep Water Blue,OME Liftplus 1",JBA 5.5 UCA ,Dynaflow cat back exhaust, Weathertech VV & mats,Mopar skids,Atthehelm front bumper, Smittybilt XRC 10, Rigid LED's,RL Skink Supersliders,Gecko Safari Basket Detroit Truetrac rear, E-Locker front, G2, Dana 4.10's

get the part number from your dealer and then search that number on ebay.

_________________
2012 Liberty Latitude 4x4,3.7L,42RLE,MP1522,D30M/8.25"@3.73,215/85R-16 LTX A/T2,Bright White
1974 CJ5,258,T14a,D20,D30/D44@3.73,TransAm Red

Hey, that looks just like mine

_________________
2010 KK Deep Water Blue,OME Liftplus 1",JBA 5.5 UCA ,Dynaflow cat back exhaust, Weathertech VV & mats,Mopar skids,Atthehelm front bumper, Smittybilt XRC 10, Rigid LED's,RL Skink Supersliders,Gecko Safari Basket Detroit Truetrac rear, E-Locker front, G2, Dana 4.10's

Thank you for the replies guys, been dealing with bigger issues. Suspension components and new wheels are here but not time to put them on. I'll take the advice on the sensors and go that route!