Tip broke off the glow plug on #1 cyl. Damaged injector and is stuck somewhere. My mechanic tells me that there are special tool required to re-time the engine after the repair. Where can I borrow them in Canada? or should i take a chance on the chrysler dealer having a mechanic to do the work?
Thanks

Howdy bailer -
you get better responses to CRD questions over in the CRD.... Love that Torque section

best bet - call the dealership and ask - CRD tools were in a special order - not everyone had them

however - for tools - to replace the belt only - you need 3 pins
check the Beesville writeup - he made his own - I'm not sure that's a good idea - but it worked for him.
http://www.beesvillebeefarm.com/jeep.html

also Sir Sam http://colorado4wheel.com/content/KJ_TB.html and GDE's http://www.keepandshare.com/doc/1729864/timing-belt-installation-pdf-february-4-2010-8-50-am-1-8-meg?da=y

and the 3 pins themselves aren't terribly expensive (although taxes and shipping to Canada add a bit) http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=64649

note - most folks go ahead and replace the water pump - which requires another tool to lock the cam gears in place



Oh yeah - Welcome to LOST - and if you get time - read through the Noob guide - lots of good information (when you get things back together)
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=54207

GDE - also loans tools - but last I heard there was a waiting list.

_________________
2005 CRD
stuff
Skeptic quod gratis asseritur, gratis negatur