Grrrrr just noticed... I'm guessing it can be the brake switch since they are all out... Running lights work... Checked fuses and they seem to be ok... Did I miss a relay or something? Maybe someone else has had a similar issue...? Please chime in if you have any info thanks in advance.

Checked all fuses associated with any and all of my lights... And replaced the brake switch... But still no brake lights at all... Not a one... Any ideas guys???

Wiring? Maybe a ground wire got detached?
If there isn't a clear broken wire, I'd use a multimeter to check for current.

_________________
2008 Liberty Sport 4x4 Automatic

Jeepin By Al 4" Lift Kit
BFG KO2’s 245/75R16
Full MOPAR skid plates
Rock Lizard Skink Super Sliders
AtTheHelm Front Recovery System & Roof Rack
M116A3 Trailer build thread: viewtopic.php?f=72&t=77997

Found a broken wire in the main bundle that runs under the drivers side foot area... I have a rusty pinhole down there... Water collects and sits in the "track" that the wires run through... Unfortunately I fear I'll have to do this one wire at a time as they break... They are all water logged, hard/stiff ...

I think the only solution would be to re route the entire bundle up and over the roof, soldering and heat shrinking one wire at a time... This is very possible but scary... Though it would give me a better advantage if submerged? LoL... I'm looking into getting the hole welded up as well... GRRRRR @ over 300,000 miles and 11 years...