This is my head gasket I took off that I need to replace, I need someone to tell me (for sure) how many notches or holes for the thickness.

http://www.davidhaggart.com/Autos/VM-En ... &k=CXQTxSn

_________________
2006 Liberty Sport CRD
GDE FT ECO/HOT Tunes.
OME 2.5
265 70r 16
SC Bumper
Glass Pack
Provent
Dodge 2500 in tank Lift pump
Samco Hoses
Rocky Road UCA
Transgo shift kit
Updated torque converter
Weeks Kit 1 & 2

viewtopic.php?f=5&t=65238

Third post down is the only reference I have ever seen on where to look for the holes or notches.

Plenty of info to be had in the service manual on what the holes mean, but nothing on where to look for them.

_________________
Matt B.

05 Limited CRD. Bought it new. 112k on the clock now.

GDE Eco-tune, rear differential drain plug (drilled and tapped the pumpkin), transmission pan drain plug, Fumoto oil valve, fuel filler neck restriction removed, front hitch, Hayden fan clutch, Sears P1 battery since 08, Mobil 1 5w40, 5 volt glow plugs, DIY timing belt at 109k

I believe the area GDE is describing is on the left side of your picture between two of the bolt holes. If so, you have a zero hole gasket which means a thickness of 1.32mm.

_________________
Matt B.

05 Limited CRD. Bought it new. 112k on the clock now.

GDE Eco-tune, rear differential drain plug (drilled and tapped the pumpkin), transmission pan drain plug, Fumoto oil valve, fuel filler neck restriction removed, front hitch, Hayden fan clutch, Sears P1 battery since 08, Mobil 1 5w40, 5 volt glow plugs, DIY timing belt at 109k

It's a zero hole gasket.

have you pressure tested your head? you sure it needs to be replaced?