Ok, now i get the gist of how to do this mod but I'm a tad confused on the locations of all the breathers. I viewed the tech article on this mod but my rear differential seems to be different then the one in the article. I'll post pictures of what I'm talking about when I get off of work.

_________________
Alec
1987 Jeep XJ
The Build Thread
Chincy 2" lift for now
31x10.50r15s
HPD30 front and D44 rear

Here's what I'm talking about.

Adam's diff


My diff


Sorry for the poor quality

_________________
Alec
1987 Jeep XJ
The Build Thread
Chincy 2" lift for now
31x10.50r15s
HPD30 front and D44 rear

Yours is the same. Notice where the hose goes into the junction block along the top of the axle housing on your friend's diff; yours has the same hose going to the same junction block.

The hose does NOT go into the relief next to the differential 'pumpkin.' It is attached with a clip higher up to keep the hose above any water you may run through.

Bob

_________________
2003 Liberty
- 3.7L V6, NP242 SelecTrac Transfer Case
- OME 927/948's, Bilsteins, JBA Gen 4.5 A-arms, JBA 1/4" top plate, 3-ring clevis, 2 extra rear isos
- Rubicon Moabs
- 4.10's, 265/70-16 Goodyear Duratracs
- 4X Guard Trans Skid, Modded BoulderBars, Mopar Engine, T-Case, Tank Skids, ARB bumper, Smittybilt 9500XRC winch

Ahhhh now I see (said the blind man as he picked up the hammer and saw) silly me. I thought that's where the hose was coming out of.

_________________
Alec
1987 Jeep XJ
The Build Thread
Chincy 2" lift for now
31x10.50r15s
HPD30 front and D44 rear