I wanted to get rid of all these power wires all over the dash and console and needed more places for 12v plug ins so this is how I solved it.
1) #2 wire coming from battery with a fuse at 60 amps there. comes through fire wall and out into 2x #12's and a #6 with fuse preotection there. #6 for future Amp or inverter.
2) 2x #12s run under dash behind radio and under center console.
3) epoxied 5 fuse accesorey block to back side of cup holder where it clears controls and is accesible throught storage compartment in console.
4)installed a six pin electrical conector to make removing console easy
breaks out as 2x #12s coming from battery, 1#12 switch leg going back (more about this later) 1 spare, and 1 ground derived by bolt on ebrake bracket
5)epoxied terminal strip for grounds
6) installed 3x 15a led rocker switches 1x for accesory ports, 1x switch leg going back under dash for cb and GPS, and 1x for future use (inverter)
7)wired line side of fuse block and terminal strip
8) installed 3xport x 1x usb spliter. i think it was like $12 problem its black and it mounts with tape
a) take apart and paint
b) mount with bolts then reassemble in place
9) install flush mount port on driver side by ebrake ( if you use a large plug in you have to unplug it to work ebrake!!!)
10) wire switches and power outlets
11) reinstall console
12) wire switch leg to 2x port outlet under dash above cover over petals. get ground from bolt on fire wall.
13) fish cb and gps power wire through dash plug in put it all back together and enjoy.
Login
Register
FAQ
Search
