TwoBobsKJ wrote:
tommudd wrote:
Nope two listed for the left side
I gave him the parts number
they ordered the right one
was sent the wrong one
They got me the right one finally
so its on, still same , right side torn out now
intermediate shaft is good , I'm running a CV on that side that the original JeepinByAl ( Al Handy) built back in the day, feels good but checking it
Next is to tear out the front diff ............................................................
still not driveable really over 35-40 due to vibes
at this point has to be something simple, and cheap hopefully

Could it be the motor mounts? I was stunned when I took out my old engine at how bad mine were. Only one of the three corners of the rubber isolator was still attached - and that section had a crack in it. Was worse on the left/driver's side but the right side was bad too.
I didn't have the vibes you're talking about but maybe bad mounts show up with different symptoms...?
Bob
Don't know they look OK, ( the motor mounts) but ???????
Both CVs out, front driveshaft is out
still has vibes
wheel bearings don't appear to have any rough areas etc
Was suppose to go help Hart today but when you can't get over 35 and haven't been over 5 miles from the house in over two weeks, didn't want to trust it.
Tried calling you Hart no answer ????
So its transmission, motor mounts or................??
Does it in 4 wheel drive or two wheel
does it going up the road all the time
vibration is the whole Jeep, steering wheel to seats
This is one that has me stumped
PLUS I'm moving.....to a house close to NAPA
that way I won't have to keep putting things back together to run get parts!