How hard is it to get the front bumper off. I got a brush guard only to figure out my jeep has been in accident and that metal piece behind bumper is crushed. Is that hsrd to replace? Any instructions on removal?

Thanks in advance

Sent from my SPH-L720 using Tapatalk 2

Turns out the front brace behind the bumper is welded support. do I gotta get it put on a frame machine to pull it straight. Joy joy

Sent from my SPH-L720

Without seeing how bad it is , then yes more than likely a frame machine will be needed.
Better to just leave the Brush Guard off anyways, most cause more damage than what they are worth

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Yes! I had frame damage there too. Fixed it with a jeep and a tow strap and 4lo. Got in an accident and the brush guard mutiplied the damage! If I hadn't have had it I would have about 1000 in damage. Instead it was 6.3k damage. Granted I still run one but just til I get an ARB.

Yea im just going to use it till jan when I can afford the arb

Sent from my SPH-L720

Correct. It is imperative that the frame is straight. Some things you can fudge, this is not one of em.

_________________
05 Silver Renegade
265/75/16 MTR's on Rubicons
F/R OME HD Kit, 3 clevis up front, 1 extra upper iso rear + JBA UCA's,
Hitch + Recovery Shackle
Boilers Gas Tank Skid
Clarion NZ409 In-dash Sat-Navigation

Sent from my SPH-L720

Sent from my SPH-L720

Best pictures I could get hopefully they can fix Tues

Sent from my SPH-L720

That's just a crash bar It's not integral to the frame what so ever (When I put on my current bumper I actually cut that piece entirely out in between the frame spars.), I replaced mine after getting into an accident and having the brush guard mangle the whole front of my jeep.