What is the plastic piece circled in the picture? I assume it is some plastic cover for wires. I ask because I accidentally drilled into it and I am trying to gauge how worried I should be.

Couldn't figure out how to post picture, so link will take you to the picture.

http://www.jeepkj.com/forum/f196/front-end-part-question-56793/#post640799

_________________
2005 Liberty CRD, 245/75R16, OME CRD Springs front, OME HD rear

Could it be the bottom support bracket for the radiator????

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve

I suspect there are wires inside it after glancing at mine. That flat vertical piece is simply held in place by tabs and looks like you can just pop it off and take a look inside to see if you have done any damage.

_________________
Sold to LOST member my 05 Ltd, GDE Stg II turbo + TCM tune, SunCoast TC w. Transgo kit, Steiger window regulators, Samcos, Fumoto valve, 2nd gen filter head with Lub. Spec. bleeder, Hayden clutch & 11 blade fan, inverted spare, P-1 battery, BF Goodrich Long Trail TAs, Etecno1 glow plugs, timing belt at 50K miles/8 yrs

You are correct. It is full of wires, in my case three of which were drilled/cut...oh well they are fixed now. Thanks for the help.

_________________
2005 Liberty CRD, 245/75R16, OME CRD Springs front, OME HD rear