2006 Jeep Liberty CRD
Headlight issues. I had the left front high beam headlight out.

I changed that bulb and checked. Now I have NO high beam head lights.

I checked the old bulb and it works fine with jumper wires.

To check the relay? http://www.youtube.com/watch?v=3JB63ebFfgU

The relay tested good. I did not think it was the relay as I had one high beam working before I touched the wires to change the bulb and now I have no high beams working

There is no power to the pin for the high beam on the bulb connector

The fuses are good

The low beams are working fine.

It was the plug under the drivers side head light. It still didn't feel like it was pushing together correctly, but it didn't seem to want to pull apart like it did before
The keeper is in place. It must not have been before. It still doesn't seem as though it is slid all the way over.
If anybody has the grill off their Jeep, could they get a picture of that connection?

Should sell the dang thang. But we are way to deep into it to get our money out of it and it isn't finished yet. Still have some wiring to do and splash guards for the trans and FS2500.

Not to mention the upper A arms won't be checked til tomorrow. The money is bad enough, but it's eating a lot of time that I need to be working on other stuff. We still have only put about 4,000 miles on this in a year.

For what we have in it we could have had a nicer 6.5 diesel Suburban and really tricked it out with an A Team turbo and all the goodies.

_________________
2006 Jeep Liberty CRD 142,000 miles New engine 2-2014, Green Eco tune, FS2500 bypass filter Weeks elbow, European Torque converter, brakes front UCA's wheel bearing and front hubs. Front hitch OEM lift pump
98 K2500 Suburban 6.5td
96 K1500 " 6.5td
95 2 door Tahoe 6.5td
94 K3500 cc srw 5 speed 6.5td
91 International Model 6 speed spicer 4700

double check the socket isn't corroded. test the light bulb on a test bench on low and high power. make sure the headlight harness isn't melted any where and arcing. has the wiring harness ever been replaced that you know of?

_________________
2012 Jeep Liberty KK 109k miles and stong
4" lift.
Gen 5.5 A-Arms
Maxxis 31x10.50x15
ATS42rle -> Jasper for the long-term win!

Not to my knowledge. I found a lose plug by the lights in the bumper cover

_________________
2006 Jeep Liberty CRD 142,000 miles New engine 2-2014, Green Eco tune, FS2500 bypass filter Weeks elbow, European Torque converter, brakes front UCA's wheel bearing and front hubs. Front hitch OEM lift pump
98 K2500 Suburban 6.5td
96 K1500 " 6.5td
95 2 door Tahoe 6.5td
94 K3500 cc srw 5 speed 6.5td
91 International Model 6 speed spicer 4700