I'm looking to buy new headlight assemblies, and I want to make sure I get quality ones.

There are some on Amazon at a good price. How can I tell if I'm getting quality headlights?

Depends on where they are made and company
Something like that I'd want Mopar or the best aftermarket I could find
See what the comments are on each brand

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Headlamps from mopar are $240. The aftermarket ones range between $30-$80. I'm not sure how to determine which aftermarkets are the best. Haven't found a lot of comments.

I installed new headlight assemblies in February that I ordered from NAPA. They were not cheap, but I'm glad I did it. I had polished the old ones a few times, but they were looking pretty sad. The new ones look ... uh ... new, plus the illumination is much better.

_________________
2003 Liberty, ARB bumper w fogs and KC SlimLites
Front Franky II HD, rear OME948 w Rancho RS9000/XL shocks
LT245/75R16C Duratracs on Moabs
4.10 gears, front & rear ARB lockers, Boulder Bars, AFE Stage 2 intake
Surco rack w BajaRack jerry can holder
Cobra 75 WX ST

06 LJ Rubi, 3.5" RE SA and 33" BFG KM2s, GenRight tank

Anyone have any experiences with the less expensive aftermarket headlights?

$30 each compared to $240 each is a huge difference for my budget.

I picked up one of these for my driver's side replacement.

http://www.rockauto.com/catalog/moreinf ... 463&jpid=0

My current one is very foggy. I was planning on attempting to swap it out this weekend. Once I do I'll post up some info about it.

I got some for like $50 on ebay and they look oem to me. of course, I am using them for a Bi-xenon retrofit so reflector quality wasnt an issue for me.

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs

The napaonline price was a little better than $240. I paid $400 for both assemblies including freight and tax. I was very happy with the quality. I didn't even have to re-aim them. That may not be in your budget, but others may find the information useful.

_________________
2003 Liberty, ARB bumper w fogs and KC SlimLites
Front Franky II HD, rear OME948 w Rancho RS9000/XL shocks
LT245/75R16C Duratracs on Moabs
4.10 gears, front & rear ARB lockers, Boulder Bars, AFE Stage 2 intake
Surco rack w BajaRack jerry can holder
Cobra 75 WX ST

06 LJ Rubi, 3.5" RE SA and 33" BFG KM2s, GenRight tank