It is currently Fri Oct 23, 2026 7:37 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 9 posts ] 
Author Message
 Post subject: Transmission problems
PostPosted: Mon Sep 07, 2015 1:04 pm 
Offline
LOST Newbie

Joined: Thu May 23, 2013 8:58 am
Posts: 4
Question, anyone else has had gearbox issues with his/her CRD? I have a 2007 2.8, 6speed manual, 82000km and when the engine is cold, no problems, once it het warm, the gears aren't going that smooth anymore. I changed the gearbox oil last week with Ms 9224 as the dealer recommend . The clutch does not slip, no cracking sounds.. Just harder to get it in the right gear.


Top
 Profile  
 
 Post subject: Re: Transmission problems
PostPosted: Mon Sep 07, 2015 6:05 pm 
Offline
LOST Addict

Joined: Fri Jun 22, 2007 11:43 am
Posts: 4962
Location: Green Cove Springs FL
Sounds to me like the clutch is not releasing properly.
Check the fluid level in the clutch master cylinder.
I suspect that the clutch master and/or slave cylinders are leaking.

_________________
U.S. Army Retired


Top
 Profile  
 
 Post subject: Re: Transmission problems
PostPosted: Tue Sep 08, 2015 2:07 am 
Offline
LOST Newbie

Joined: Thu May 23, 2013 8:58 am
Posts: 4
Can you tell me where I can find this cylinder ?


Top
 Profile  
 
 Post subject: Re: Transmission problems
PostPosted: Tue Sep 08, 2015 5:19 am 
Offline
LOST Addict

Joined: Fri Jun 22, 2007 11:43 am
Posts: 4962
Location: Green Cove Springs FL
Here in the states, there are no CRD models with a manual transmission.
So I have never even seen one.
My best guess is that the clutch master cylinder is under the hood and looks like a small brake cylinder.
The slave cylinder is probably inside the transmission bellhousing.

_________________
U.S. Army Retired


Top
 Profile  
 
 Post subject: Re: Transmission problems
PostPosted: Tue Sep 08, 2015 5:22 am 
Offline
LOST Newbie

Joined: Thu May 23, 2013 8:58 am
Posts: 4
Ok thanks for the tip, I'll have a look. But if it would be leaking, I would have to see some drips here and there, right ?


Top
 Profile  
 
 Post subject: Re: Transmission problems
PostPosted: Tue Sep 08, 2015 5:35 am 
Offline
LOST Addict

Joined: Fri Jun 22, 2007 11:43 am
Posts: 4962
Location: Green Cove Springs FL
You might see drips, you might not.
Sometimes the internal seals will go bad and make it so it cant hold the pressure but never drip outside of it.

_________________
U.S. Army Retired


Top
 Profile  
 
 Post subject: Re: Transmission problems
PostPosted: Wed Sep 09, 2015 11:08 am 
Offline
LOST Junkie
User avatar

Joined: Sat Mar 06, 2010 7:10 pm
Posts: 664
Location: Cambridge, United Kingdom
If this happens only when cold, it's the syncromesh in the gearbox that have stiffened up. it's a common problem in 5 & 6 spd Jeep gearboxes (see XJ & TJ). You have two solutions, change to oil again to the correct one by Mopar or ATF 4 for the Auto gearbox that sometimes does the trick. Mine plays up at temperatures below 13C and is a real pain through the winter until be box has fully warmed up. After it's okay. I even had the gearbox rebuilt by Jeep 5 yr ago and now we are back to the same problem after 70K miles ( I have now 140K miles on the clock).

_________________
CRD 2.5 2003
Image
Snorkel
Curt Front Hitch+Warn M8000 & Cradel
Asfir Front, Gearbox,Transfer Skid + Mopar Tank Skid
BF Goodridge KM2 & General Grabbers AT 245/75R16
OME NS131&790 + NS132L&948, 3/8 Boiler Top Plate, JBA 4.5, 2 Top Rear Isolators


Top
 Profile  
 
 Post subject: Re: Transmission problems
PostPosted: Wed Sep 09, 2015 12:02 pm 
Offline
LOST Newbie

Joined: Thu May 23, 2013 8:58 am
Posts: 4
That's the thing, when it's cold, no problem, only when it's warm and need to shift a lot..


Top
 Profile  
 
 Post subject: Re: Transmission problems
PostPosted: Thu Sep 10, 2015 7:10 am 
Offline
LOST Junkie
User avatar

Joined: Sat Mar 06, 2010 7:10 pm
Posts: 664
Location: Cambridge, United Kingdom
Looks like you have the opposite problem I have, cold fine , warm hard to shift.... I guess it might be linked to the oil you have used then, not enough lubrication, I would suggest to change oil and make sure to use Jeep oil.

_________________
CRD 2.5 2003
Image
Snorkel
Curt Front Hitch+Warn M8000 & Cradel
Asfir Front, Gearbox,Transfer Skid + Mopar Tank Skid
BF Goodridge KM2 & General Grabbers AT 245/75R16
OME NS131&790 + NS132L&948, 3/8 Boiler Top Plate, JBA 4.5, 2 Top Rear Isolators


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 9 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com