Anyone else had these go bad? Would a CRD be the same as other liberty's? I found a write up on another forum. I found lots of metal shavings inside them and the rubber seams to be rotted out and gone. Could you check the pics and confirm this is the rear ball joint bushings?








I found this online, Seems to be the same part http://www.amazon.com/gp/product/B00B8K ... PDKIKX0DER



Ben

_________________
05' Silver CRD Limited, GDE ECO Tune, WEEKS Stage 1, Elephant Hose Mod, Interior LEDs, Pioneer System, 190k miles

Work Done: New A/C System Complete, New Front Drive Shaft, ETECNO 7V Glow Plugs, New Rear Upper Control Arm
Future Work: WEEKS Stage 2, New TC, GDE Tow, Tires,

That's the one. They go bad around 100k or so with no lift. I hear that OEM is better.

_________________
05 CRD: H.D.S2 stat,WW Ironrock trilink&LCA's, OX rear,ARB front, 4.10's, ARB bumper, Suncoast,OME 3.5, JBA UCA,rock rails, Moabs&265/75 Duratracs, GDE tunes ,FFD fan,ARP's, 2 micron fuel, new valves,sasquatch battery tray & grid heater, tensioner relocated
Mech fan, VH & AC delete

Thanks. do you know if the OEM has all the pieces pressed in as needed? I would prefer to purchase the entire assembly. I do not have a press.

Ben

_________________
05' Silver CRD Limited, GDE ECO Tune, WEEKS Stage 1, Elephant Hose Mod, Interior LEDs, Pioneer System, 190k miles

Work Done: New A/C System Complete, New Front Drive Shaft, ETECNO 7V Glow Plugs, New Rear Upper Control Arm
Future Work: WEEKS Stage 2, New TC, GDE Tow, Tires,

pretty sure it does. Yours is too rusty to reuse anyhow.

_________________
05 CRD: H.D.S2 stat,WW Ironrock trilink&LCA's, OX rear,ARB front, 4.10's, ARB bumper, Suncoast,OME 3.5, JBA UCA,rock rails, Moabs&265/75 Duratracs, GDE tunes ,FFD fan,ARP's, 2 micron fuel, new valves,sasquatch battery tray & grid heater, tensioner relocated
Mech fan, VH & AC delete

I got the wishbone from napa, less than 200 (140-ish couple years ago), comes with bushings and balljoint. It's same. As gassers.

_________________
2005 kj CRD, samco, suncoast tc, provent, Kennedy lift pump, GDE ECO full torque, 2nd gen filter head, 245/70/16 a/t tires, mopar light bar, fumoto oil valve, OEM Skid Plates, ARB Front bumper and HD OME, tru cool LPD47391 40k GVW tranny cooler (stock cooler delete), FF Dynamics e-fan and shroud, rocker arms replaced, HDS2 190F thermostat.