It is currently Tue Nov 03, 2026 9:28 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 6 posts ] 
Author Message
 Post subject: New tires
PostPosted: Thu Jan 23, 2020 2:24 am 
Offline
LOST Member

Joined: Sat Jan 11, 2020 7:52 pm
Posts: 103
Location: New Mexico
So I have a 2006 Jeep Liberty crd all stock but I have tired that are 245/70R16 and I was just wanting to know if putting 245/75R16 tires would do anything.


Sent from my iPhone using Tapatalk

_________________
2006 Jeep Liberty CRD
Located in New Mexico
Owned since Aug 2018


Top
 Profile  
 
 Post subject: Re: New tires
PostPosted: Thu Jan 23, 2020 9:02 am 
Offline
LOST Addict

Joined: Tue Dec 16, 2014 9:33 pm
Posts: 1128
Location: Jackson,TN
That size tire is about an inch taller than your present tires but should fit without rubbing etc. You may get slightly better fuel mileage maybe 2-3 percent at most. It will also change your effective drive ratio and speedometer and if equipped the mileage and fuel mileage readings on EVIC (overhead display.) So you won't accelerate quite as fast but probably barely noticeable if at all. This change should not require trimming or lifting or wheel spacers etc.

_________________
05 Blu LIM, OME GDE Tbo, wk II 245/75/17, KC Lights, bull bar, 195K H TC
05 Blu Lim, Dayton, GDE HT, 255/75/18 , 210K , H TC
06 Bla Lim, GDE Eco, Destination AT 245/75/17, 151K, H TC
06 D Khaki Lim 126K wkII Eur TC
05 D khaki Lim 145k refurbishing
All CRDS: Fumoto, Lift , Fan Shroud mod, fuel head Gen II, SAMCOS,self TB, 2 Mic filt, Hayden


Top
 Profile  
 
 Post subject: Re: New tires
PostPosted: Thu Jan 23, 2020 9:50 am 
Offline
LOST Addict

Joined: Fri Jun 22, 2007 11:43 am
Posts: 4962
Location: Green Cove Springs FL
Speaking from experience here.
245-75-16 tires will rub without any kind of lift.
How much rubbing depends on how much your front springs have sagged.
At a minimum, you will need to pound flat the pinch welds and add at least 1 inch of lift.
1 inch of lift can be achieved with four 2 inch conduit nuts on each side, slid onto the bottom of the front shock mount between the clevis bracket.

_________________
U.S. Army Retired


Top
 Profile  
 
 Post subject: Re: New tires
PostPosted: Thu Jan 23, 2020 9:13 pm 
Offline
LOST Member

Joined: Sun Apr 06, 2014 5:23 pm
Posts: 461
flash7210 wrote:
Speaking from experience here.
245-75-16 tires will rub without any kind of lift.
How much rubbing depends on how much your front springs have sagged.
At a minimum, you will need to pound flat the pinch welds and add at least 1 inch of lift.
1 inch of lift can be achieved with four 2 inch conduit nuts on each side, slid onto the bottom of the front shock mount between the clevis bracket.


You're right,

In my case I have a bit of rub on one side with Ko2 245/75r16 and a OME suspension !


Top
 Profile  
 
 Post subject: Re: New tires
PostPosted: Thu Jan 23, 2020 9:18 pm 
Offline
LOST Addict

Joined: Tue Dec 16, 2014 9:33 pm
Posts: 1128
Location: Jackson,TN
that may well be I was comparing to size he had and not stock size a .9 inch increase or .45 inch difference in fender clearance . That being said I have had 245/75/17 which are 31.5 inches diameter on stock suspension that barely rubbed without trimming and didn't need a lift but may have had spacers. But in changing tire/wheels from one of mine to another I have noticed that yes the spring sag can be different but I have also noticed one of 4 has about a 1/3 inch closer spacing to firewall, I guess the whole body slightly further forward. car fax didn't show any accidents and it doesn't appear to be repainted any.

_________________
05 Blu LIM, OME GDE Tbo, wk II 245/75/17, KC Lights, bull bar, 195K H TC
05 Blu Lim, Dayton, GDE HT, 255/75/18 , 210K , H TC
06 Bla Lim, GDE Eco, Destination AT 245/75/17, 151K, H TC
06 D Khaki Lim 126K wkII Eur TC
05 D khaki Lim 145k refurbishing
All CRDS: Fumoto, Lift , Fan Shroud mod, fuel head Gen II, SAMCOS,self TB, 2 Mic filt, Hayden


Top
 Profile  
 
 Post subject: Re: New tires
PostPosted: Thu Jan 23, 2020 9:21 pm 
Offline
LOST Addict

Joined: Tue Dec 16, 2014 9:33 pm
Posts: 1128
Location: Jackson,TN
let me put it this way you will have about 1/2 inch less clearance to firewall and fender well than you do now.

_________________
05 Blu LIM, OME GDE Tbo, wk II 245/75/17, KC Lights, bull bar, 195K H TC
05 Blu Lim, Dayton, GDE HT, 255/75/18 , 210K , H TC
06 Bla Lim, GDE Eco, Destination AT 245/75/17, 151K, H TC
06 D Khaki Lim 126K wkII Eur TC
05 D khaki Lim 145k refurbishing
All CRDS: Fumoto, Lift , Fan Shroud mod, fuel head Gen II, SAMCOS,self TB, 2 Mic filt, Hayden


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 6 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com