Rrusse11 wrote:
Newbie here, but I would assume any comprehensive tune would include re-programming the transmission. In my very limited experience with the 5 spd auto, it shifts too soon for the torque band of the diesel, overpowering the TC. Rightly or wrongly, I'm using the OD button to help control
the tranny, letting it rev a bit higher before shifting in the high gear(s). Keeping it in 2nd around town gives some engine braking and more control over momentum rather than constantly having to ride the brakes. Dyed in the wool manual tranny fan here, I feel the auto is the one big drawback to the CRD.
Keep in mind the ECM & TCM are separate control devices. Reflashing for a better engine tune does not affect the software or files on the TCM.
I respectfully disagree with you on shift points. If you retune your diesel for more HP & higher torque and have a very good torque converter like the SunCoast along with the new updated front pump assembly and TransGo Kit installed, it will handle the lower shift points & TC lockups flawlessly. This engine makes lots of power at lower RPMs if tuned properly.
Actually, the transmission retune that GDE used to provide, before they got busted by the EPA, lowers both shift and TC lockup points in 4 & 5 gears, but it does require a very good TC to handle it and not slip or shudder in lockup accelerating uphill. I have a Stage IV Hot Tune and one of GDE's eco transmission tuned TCM's and they function together seamlessly without any TC issues.
I rarely every run this engine above 2500 RPMs as it just isn't necessary with all the power it makes around 1800-2000 RPMs.
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited 
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve