Can I put a trans. temperature gauge in the cockpit or use my Torque scan gauge?

_________________
Marty

'05 CRD, GDE tune(s), JBA stuff, OME, Weeks Stage I & II, "Provent"(custom) +++

I don’t know of any scan tool that can read the transmission temp.

I bought a cheap $10 digital temp sensor/gauge, zip tied the temp sensor to the transmission output line to the cooler, and wrapped it in insulation.
Works decent but there are better ways.

_________________
U.S. Army Retired

Never did find a way to read the transmission temperature using a scanner, so I installed a gauge.
See this post where I covered the install of a transmission temperature gauge on the "A" pillar:> viewtopic.php?p=927960#p927960
I installed the temperature sensor in a "TEE" block in the cooling line going to the OEM transmission cooler.
I got the "TEE" block on line, worked great.

I also added a 10 row "stacked plate" oil cooler in the opening under the bumper.
See this post:> viewtopic.php?f=98&t=89140

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve

Thanks so much for the info!! It was a great help!!

I'll be gathering the parts for my next project in the coming months.

_________________
Marty

'05 CRD, GDE tune(s), JBA stuff, OME, Weeks Stage I & II, "Provent"(custom) +++