During hot weather I have been having problems with my a/c. It would start out cooling fine and then when the engine gets warm it would quit cooling very erratically. I took it to the dealer before leaving Delaware and it put out 38 F for them when in the shop. Of course when I left the weather got hot later in the day and a/c starter performing badly.
I had to leave for a trip from the east coast to the west coast so I hooked up the gauges and checked pressure. It looked like it was a little low so I added a can of Freon with dye in it. I stuck a thermometer in the center duct and left for the west coast the next morning.
I noticed that the a/c would still quit and would watch the gauge go from 50 to 80 then back down so often. I continue to northwest Washington where the temperatures high are usually in the 70 during the worse part of the summer. Of course I didn’t have any problems when I was there for the pass month.
I left Washington four days ago and had trouble as soon as I got to eastern Washington. When I got to Montana the temperature outside hit 100 F and the a/c center duct would only put out 90 F most of the time. This is with me driving at 70 mph! I noticed that when I coasted down a long grade that the a/c temperature would start putting out 60 F.
The first thing the next morning in I took it to a dealership and it shows 45 F out the center duct for them of course. As soon as I left and hit I90, the a/c quit again. I began to figure that something was getting hot and the ECM was shutting the a/c down. I know that the engine temperature gauge always stayed in the middle so I was stumped.
At the next rest area I lifted the hood and plugged the MAF back in and went on my way. To my surprise that solved the problem for the temperature out the center duct stayed 40 – 50 F for the rest of the trip to the east coast.
Can anybody tell me why????
