It is currently Sun Nov 01, 2026 9:07 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 8 posts ] 
Author Message
 Post subject: Oil Consumption
PostPosted: Wed Oct 15, 2008 11:10 pm 
Offline
LOST Newbie

Joined: Fri Jan 19, 2007 12:03 pm
Posts: 47
I have an 05 CRD that I'm a little concerned with how much oil is being consumed. I have noticed that it is using just over a
quart of oil in about 3,000 miles. I have added a provent, and the provent was completely covered in oil in a very short time
period. The provent seems to have made no change in the amount of oil that is being consumed. The 05 has not been F37'd.

There are no signs of leaking and no oil spots under the jeep. I know diesels can consume some oil, but the amount and short
period of time has me concerned. I have a 06 CRD and can go the full 6,000 miles between oil changes and it does not consume
any oil that is noticeable on the dipstick.

Any thoughts.


Top
 Profile  
 
 Post subject:
PostPosted: Thu Oct 16, 2008 3:59 am 
Offline
Lifetime Member
Lifetime Member

Joined: Tue Sep 18, 2007 7:21 pm
Posts: 3092
Location: Texas
Air filter....................

_________________
'05 CRD Limited
Pricol EGT, Boost
GDE Hot '11; EDGE Trail switched
SEGR; Provent; Magnaflow;
Suncoast T\C, Transgo Tow'n'Go switch;
Cummins LP module, Fleetguard filter, Filterminder
2.5" Daystar f, OME r; Ranchos; K80767's, Al's lifted uppers
Rubicons, 2.55 Goodyears
Four in a row really makes it go


Top
 Profile  
 
 Post subject:
PostPosted: Thu Oct 16, 2008 6:28 am 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Wed May 24, 2006 6:52 am
Posts: 3442
Location: Columbus, Ohio. USA
The dipstick is marked MIN and MAX and many make the mistake of filling to the MAX :shock: Try putting in the specified 6.3 quarts and see where it comes on the stick and scratch a line and remember this is FULL :wink:

_________________
Atlantic Blue 06 CRD Limited (his)
Joined by a 2000 XJ Classic (hers)


Top
 Profile  
 
 Post subject:
PostPosted: Thu Oct 16, 2008 9:35 am 
Offline
LOST Newbie

Joined: Tue Sep 12, 2006 12:43 am
Posts: 94
Location: ALASKA
My full mark is at the min mark and thats were i keep it :shock:

_________________
2005 CRD Sport 4x4
EHM,ORM,Straight pipe exhaust,Facet 40109 lift pump


Top
 Profile  
 
 Post subject:
PostPosted: Fri Jan 02, 2009 8:59 pm 
Offline
LOST Junkie
User avatar

Joined: Sat Dec 20, 2008 7:02 pm
Posts: 607
I got the my CRD a few months ago and I checked the oil a lot when I first got it and it never used any. I just did the first oil change to Rotella T full syn 15w40 and its been cold here in MI and not after 3000k miles its down to the min mark. I guess I'll leave it at the min mark and check it a lot to make sure it doesn't get any lower... any other ideas would be great too !

_________________
-05 Dark Khaki Limited CRD. GDE ECO tune. In-tank lift pump, Transgo doo doo kit, B&M trans cooler, replaced trans solenoid pack and filters, Newer Michelin tires, Timing belt with all related parts replaced at 110,000miles.


Top
 Profile  
 
 Post subject:
PostPosted: Fri Jan 02, 2009 9:38 pm 
Offline
Lifetime Member
Lifetime Member

Joined: Tue Jul 05, 2005 8:23 am
Posts: 3544
Location: New Braunfels, Texas
Also like mentioned earlier, check the condition of your Air Filter. If it is clogged you will suck oil and fill your provent.

_________________
Founder of L.O.S.T.
2006 CRD Sport

Mods: GDE Hot Tune w/ 364#@2000rpm/Air Box /3" Str8 Exhaust/ASFIR Alum Skids/245-75R-16 Cooper STT PRO/OME LIFT w/Clevis & 4 Spring Isos/AirTabs/Rigid 10" S2 LED/4xGuard Ctr Matrix Bumper
Drag Strip:Reac=.1078_60ft=2.224_1/8=10.39@64.8mph_1/4+16.46@80.8mph


Top
 Profile  
 
 Post subject: Always check with the Engine cold and park in...
PostPosted: Fri Jan 02, 2009 10:08 pm 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Sat Jun 09, 2007 10:49 pm
Posts: 3554
Location: Aurora, IL
....the same place. Oil can collect in the upper parts of the engine and take hours to drain back. To find out if your dipstick is telling the whole truth next time you change the oil. First add the 6.3 Qts of oil, start the engine and drive it around until it is warmed up and park it. Check the oil level the next morning and note where it wets the dipstick. It could be something as simple as not having the dipstick tube all the way into the block or pan where it goes in.
After you check all of that stuff above and items in the other posts including the air filter, you may have your rings carboned up and you could fix that with a good road trip. Many years ago we would hook up the old 4020 John Deere's to the Dynometer and put them to work and reseat the rings that were carboned up. Oil consumption would drop and power output would increase a bunch.

Beats pulling the engine down :idea:

_________________
2006 Pearl Green CRD
Magnaflow 2 1/2" Cat Back
KJ Extra Leg Room Brackets, Carter Lift Pump, V6 Airbox, ORM
Fuel cooler, Oil Separator, Progard 7
Gauges EGT Boost Trans Temp Oil Pres, Michelin LXT AT2 245 70 R16
7,000# Draw Tight hitch, PML EX Deep Trans Pan
Centrifuge, SunCoast, Transgo, RAM TCM, InMotion Stage 2
Wife's 99 TDI VW Beetle


Top
 Profile  
 
 Post subject:
PostPosted: Fri Jan 02, 2009 10:14 pm 
Offline
LOST Member

Joined: Thu May 08, 2008 11:29 am
Posts: 471
Location: Anchorage
I find that Rotella T 5-40 blue bottle has higher consumption than m1 0-40 or m1 tdt 5-40. I don't think i am alone in this. I do my 6.5qt (i use a m1-301 filter) and with rtsyn it ate 2/3 qt in 5k the others have only been about 1/4-1/3 in 7k. there are other variables that could have lead to this consumption other than the oil itself, but;

I feel that m1 tdt is the best oil that I can find locally/easily and would use it regardless; it's only a few dollars more than rtsyn and it's just peace of mind for me. I am working on extended OCI's and figured i'd get longer oci's faster by working up with tdt.

The only reason I say any of this, is simply to point out that, although I don't use rtsyn any more, I do think it is a great oil, and would recommend it in a heartbeat, if you don't experience larger consumption (like many have in other motors) or do, but don't mind, it's possibly the easiest to find and one of the best 5-40's in the world. And it's defiantly one of the most affordable HIGH quality 5-40's around. No, you may not get 30k oci's from it. But you were not going to run it that long anyway, were you?

The next time you buy your rtsyn make sure it's the newer cj-4 and not ci-4, same price, better oil.

_________________
06 CRD Limited. IMII, GDE TCM, Carter transfer pump, Upgraded oem primary, 2 micron secondary, 3 inch mandrel straight pipe.
Transgo shift kit, EHM, fcv butterfly removed, egr plated off. 19 3/8 solid flex fan, no electric fan, 10k lb aux trans cooler.
Frankenlift II, Mopar skids, allj's rails, 235/85 km2 on stock rims


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 8 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 10 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com