Got it fixed. Tapped it with a 1/4". Put a 1/4" plug on it with a new coupler.
And to top it off, I got an Air Chuck With Clip.

Now I just need to find a new filter!

Those are the best $50 accessory I know of for a 4x4. I've aired up 25 times or more with mine so far.

_________________
2002 KJ Limited
Select Trac
3.7L V6
45RFE automatic
OME heavy springs
Bilstein HD strut and 5125 extended rear shock (not quite bolt in - just some spacers needed)
Yokohama Geolander AT-S 245 75r16

Advance Auto Parts carries them. It's not the same brand name, but still the same chinese filter. Look in the so called "performance" section.

If you want a quality product, tell the guy at the counter to pull up the K&N book. They make crankcase breathers too in many sizes and shapes.

_________________
04 Rocky Mountain Edition
Detroit Truetrac in the front, Rusty's 2.5" Coil Lift, Revos
Custom Roof Rack w/ 4 Hella 500s, Optima Red Top, Mopar Rock Rails, All Mopar skids

Australian 4wd Action magazine had a huge compressor comparison last month, and they tested 3 different compressors that used the same body castings as yours - all made in China, but apparently the internals (bearings, piston, etc) will vary in quality depending on who they are made for.

I have the TJM version which works just fine.

You will never be able to use air tools directly off a compressor like that: you will need an intermediate tank to get any use at all, and even then you will have to wait for the tank to recharge. You will also need a pressure switch on the tank to cut the compressor when it reaches max. tank pressure as this will probably be less than max. compressor output.

_________________
November 2006 2.8 CRD manual, CRDSTU front springs, King HD rears, Polyairs, LT245/70R16 Pirelli Scorpion ATRs, DP chip, Airflow snorkel
TJM alloy front bar, Ox 9500lb winch, Hella Compact 4000 spots, Complete set Mopar skid plates, Mopar cargo barrier
GME TX3440 UHF, Codan NGT HF

I'm notreally going to use compressor tools...
really just got it for air for tires!

mounted my Hose today... just used some steel that was hanging around and connected it.

That's a nice compressor. How does it work for you? I just have 2 cheap compressors from can tire. Thanks to the libby having an accessory plug-in in the back i can use both at the same time cutting the fill up time in half.

I like the clean install

_________________
2008 KK Liberty Sport NIGHT OPS EDITION + GILLS
OEM & Custom Skids - Factory Tow Package - Rock Lizard Skink Super Sliders
Prototype JBA 4 Inch Lift - JBA UCA's - Flowmaster Super 44 OR - Whacked Resonator
Jet Stage 2 - RL Gecko Basket Rack - Custom Winch Bumper - Recon 10.5K Winch

Lookin' Good Mang!

_________________
05 Renegade - Dark Khaki Pearl
Frankenlift IIP, Stealth JBA 4.5's, Mobil1 Synth.& Filter, PIAA Extreme White, Amsoil EA Filter (RIP), Spidertrax 1.25, 245/75/16 Duratracs

Found these in the performance section of my local Autozone:

Breather filters, looks pretty much like what you wanted.

Yes, sir that is what I am wanting.. I have searched all of m local auto zones, pepboys, o'reily's and napa, and they do not carry them...