A harness plug over by my experimental TCM that I wrapped up in rags instead of mounting on the bracket got knocked loose just enough to unlatch the clip

. Yup, one of those Fricken Chrysler harness plugs that will even make some Atheists Pray just to get it unplugged, was knocked loose by the TCM wrapped up in rags bouncing around

.
Just think what some AC Shop would have charged me for evac, recharge, low pressure switch, blend door actuator, recirc actuator, ECM, ambient temp sensor, on and on, bunch.
Goes to show when you want to experiment you better be ready to take the responsibility. Who would think a harness plug getting knocked loose can cause all the problems, but it did.
So if your AC system acts like it is possessed, reach down to the harness plugs near the TCM and push all three of the plugs back together, might cure the problem.
Oh; The relay I replaced was bad too.