I'm going to replace a inner CV boot tomorrow. What have you guys used to crimp the bands going around the boot? Did you have to buy the tool?

_________________
Ray's Renegade
L.O.S.T # RP052495
Light Khaki 2005 Renegade 4x4
28D package (full skids)
Trailer tow group
Auto tranny
Trac-Loc
Jeep seat covers
K&N air filter
Moog K3199 LBJs
Frankenlift
Al's upper A arms
Goodyear wrangler silent armor
255/70-16

anyone?

Thanks

_________________
Ray's Renegade
L.O.S.T # RP052495
Light Khaki 2005 Renegade 4x4
28D package (full skids)
Trailer tow group
Auto tranny
Trac-Loc
Jeep seat covers
K&N air filter
Moog K3199 LBJs
Frankenlift
Al's upper A arms
Goodyear wrangler silent armor
255/70-16

on my 91 chevy 4x4 when i replaced the boots i used worm clamps ( hose clamps). this is alot easyer and just as strong! with the worm clamp you know that it is on tight! i could never get the clamp that you are talking about to seal completely plus with the worm clamp it wont let water in!

thanks... i'll have to find some thin ones.

I just was woundering if there was an easy way to crimp the ones that came with the boot.

_________________
Ray's Renegade
L.O.S.T # RP052495
Light Khaki 2005 Renegade 4x4
28D package (full skids)
Trailer tow group
Auto tranny
Trac-Loc
Jeep seat covers
K&N air filter
Moog K3199 LBJs
Frankenlift
Al's upper A arms
Goodyear wrangler silent armor
255/70-16

not unless you get a tool that the dealer uses!!!! also it will not mess with the balance so you should not have any vibration from the little screw on the body of the clamp!!! GOOD LUCK ITS THE BEST I CAN DO FOR YOU!!

autozone has a CV clamp tool listed in their tool loaner program.

If you want to buy some .. they have them at NAPA