I have to pull the engine for a rebuild, and need to removed the A/C compressor and Injection pump from the engine.
Is there any way to do this without dropping $275 into the Vm.1067 tool?

_________________
2006 Jeep Liberty CRD, SAMCO CAC Hoses, GDE Eco Tune

GDE may be willing to rent it. Email Keith.

DOC

_________________
2005 KJ CRD Ltd Detroit TrueTrac Bilsteins G2 GDE "HOT" ECU GDE TCM "Tow Tune" "euro" TC SEGR Weeks Elbow New HG at 130K ARPs Clean CAT aFe Filter Magnaflow Exhaust EHM Cumminos In-Tank Lift Pump Hayden Fan Clutch Nylon Fan VH Enabled with GDE lower shutoff point Recalibrated Temp Gauge Tekonsha Prodigy Sears P-1 ZDDP

Most of the time you can improvise these special tools but if you want the real thing there's a couple on ebay at the moment for half that price.

_________________
Share your ideas freely at https://www.facebook.com/groups/libertydiesels/

Thanks, I didn't see those on ebay, but I just made an offer on one.

_________________
2006 Jeep Liberty CRD, SAMCO CAC Hoses, GDE Eco Tune

yes.. its possible..I did it..
change the timing belt and CP3 without the proper tools..

will I do it that way again..NO!
too much of a pain in the butt..

I would guess it took me an hour just to get the new timing belt back on..then time to check that it was right..
then reassemble..

-dkenny

_________________
84 BB school bus, DD8.2L turbo ->the transmission died..too expensive to fix..it'll be heading to the scrap yard..4/11)..Bus gone to Scarp 8/23/11
06 Liberty CRD
'99 dodge ram 2500 quad cab, 4x4, 24v
all Biodiesel powered when its warm enough

I didn't get the right tool to hold the injection pump gear, but my air impact knocked the nut off in short order, and the tool made it easy to pull the gear.

Sent from my DROID RAZR HD using Tapatalk

_________________
2006 Jeep Liberty CRD, SAMCO CAC Hoses, GDE Eco Tune