Got head and cover back on. Pins in. Belt on correctly. Pulled pins and hand turning over. Engine locks up after about quarter turn. Is there more than one small hole in flywheel for the line up pin?

Sent from my SM-N950U using Tapatalk

Yes. There are several holes in the flywheel. Is the crank set to 3 o clock?

Sent from my Pixel 3 using Tapatalk

_________________
SOLD - 2006 Jeep Liberty CRD Limited
Gen2 Fuel Head - Magnaflow Exhaust - Ram transmission swap - In-Tank Lift Pump
Moab Wheels - 245/75/R16 LR E Cooper Discoverer AT3 Tires - OME Lift 790/90009 948/60069 - Etecno Glow Plugs - V6 Airbox
Pic of my Jeep!

Sorry, nob, how do I tell? What will line up with 3 o'clock?

Sent from my SM-N950U using Tapatalk

Just as ebbnflow said, there are several holes in the flywheel.
But there is a dimple index mark on the crankshaft that should be set at 3:00 when you have the pin in the correct flywheel hole.
Note: you may have to do a little cleaning to see it!

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve

Perfect, thanks!

Sent from my SM-N950U using Tapatalk

remember we talked about this 8/9
viewtopic.php?f=5&t=90307

the pistons should all gave been at equal height when you had the head off if the pin was in correct hole at 90 degrees ATDC

_________________
05 Blu LIM, OME GDE Tbo, wk II 245/75/17, KC Lights, bull bar, 195K H TC
05 Blu Lim, Dayton, GDE HT, 255/75/18 , 210K , H TC
06 Bla Lim, GDE Eco, Destination AT 245/75/17, 151K, H TC
06 D Khaki Lim 126K wkII Eur TC
05 D khaki Lim 145k refurbishing
All CRDS: Fumoto, Lift , Fan Shroud mod, fuel head Gen II, SAMCOS,self TB, 2 Mic filt, Hayden